We accept payments via PayPal only.
You need CCcam 2.0.9 or newer or Incubuscamd compatible box/device
All you need is a satellite dish pointing at your desired provider (for example: Thor 0,8E for Canal Digital), a Dreambox or similar running CCcam and a broadband connection.
No, once you order from us we send you a single line of code which you insert into a file on your reciever. This tells the receiver where in the world our servers are and how to communicate with them.
Card sharing is a method by which independent receivers obtain simultaneous access to a pay television network, using one legitimate conditional access subscription card. Typically, the legitimate card is attached to a personal computer or Dreambox which is connected to the Internet, and is configured to provide the legitimately decrypted control word to other receivers who request the information. This decrypted control word is then used to decode an encrypted conditional access service, as though each other receiver were using its own subscription card.
You can receive only those channels that your satellite dish is able to receive. If you have a motorised system with a dish of a suitable size then it may be possible to receive all of the channels listed.
We recommend you install the Gemini firmware image (although all other firmware images should work fine) on your Dreambox as this is the easiest software to use with your Dreambox.
We recommend you use the latest version of CCcam or MgCamd (or any other EMU that uses C Lines) to connect to our servers.
No. We support only CCcam and MgCamd (or any other EMU that uses C Lines).
Yes. You can use any receiver including PC based receivers that will run the CCcam or MgCamd (or any other EMU that uses C Lines). Please check with the manufacturer of your receiver to see if it can use CCcam before joining the service.
No. We only offer packages that are listed on the Packages page.
We will only send you the C line needed to connect to our servers. Although we recommend that your CCcam.cfg is empty before adding C line. If you don't have CCcam.cfg, you will need to make one.
No. We do not allow you to use C line on more than 1 receiver, but we offer you Multi Room option. To learn more, you can check it out here.
To learn more about becoming a reseller, click here.
There may be few solutions to solve the issue with picture freezing:
1. Please make sure that you same C line only for 1 receiver at the time.
2. Remove everything from CCcam.cfg except the given C Line
3. Turn off receiver, wait few seconds, then turn it back on.
If nothing above helped you, please contact us.
If your picture is getting blocky, please check the signal you're receiving from your satellite